2006-2011 Camry Aurion · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built Jun 2006 – May 2009


1. REMOVE FRONT BRAKE PAD
  1. Remove the 2 brake pads from the front disc brake cylinder mounting.


2. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 2 front disc brake pad support plates.


3. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

  1. C143465
    Remove the 2 bolts and front disc brake cylinder mounting.


4. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C143482E02
    Remove the front disc brake cylinder slide pins from the front disc brake cylinder mounting.


5. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

  1. C143467
    Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


6. REMOVE FRONT DISC BRAKE PISTON

  1. C111364E09
    Prepare a wooden plate to hold the front disc brake pistons.

  1. Place the wooden plate between the front disc brake piston and the disc brake cylinder assembly.

  1. C143463
    Use compressed air to remove the front disc brake piston from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.


7. REMOVE CYLINDER BOOT
  1. Remove the cylinder boot from the disc brake cylinder assembly.


8. REMOVE PISTON SEAL

  1. C143464
    Using a screwdriver, remove the piston seal from the disc brake cylinder assembly.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.


9. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

10. REMOVE FRONT DISC BRAKE BLEEDER PLUG

11. REMOVE FRONT DISC

  1. C132801E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.

← REMOVAL (Jun 2006 – May 2009)INSPECTION (Jun 2006 – Sep 2006) →