2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B150434E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150436
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150438
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


2. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B150435E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150437
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150439
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.

← COMPONENTS (from Jun 2009)REMOVAL (from Jun 2009) →