REMOVAL
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
|
 |
- Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
| 2.
REMOVE DOOR ASSIST GRIP COVER
|
 |
- Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the door assist grip cover.
| 3.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
|
 |
- Remove the 3 screws.
Using a clip remover, disengage the 7 clips.
- Raise the rear door trim board to disengage the 4 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.
Disconnect the connector.
- Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.
- Disengage the clip as shown in the illustration and remove the No. 1 door scuff plate clamp from the rear door trim board.
| 4.
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
|
 |
- Disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.
| 5.
REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
|
 |
- Disconnect the cables and remove the rear door inside handle sub-assembly.
| 6.
REMOVE REAR DOOR SERVICE HOLE COVER
|
 |
- Disconnect the connector.
Remove the rear door service hole cover.
- HINT:
- Remove the remaining tape on the door side.
| 7.
REMOVE REAR DOOR GLASS RUN
|
 |
- Remove the rear door glass run.
| 8.
REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
|
 |
- Remove the 2 bolts, the screw, and the rear door lower window frame sub-assembly.
| 9.
REMOVE REAR DOOR QUARTER WINDOW GLASS
|
 |
- Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.
Remove the rear door quarter window glass from the rear door quarter window weatherstrip.
| 10.
REMOVE REAR DOOR GLASS SUB-ASSEMBLY
|
 |
- Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
- NOTICE:
- Do not damage the door glass.
| 11.
REMOVE REAR DOOR WEATHERSTRIP
|
 |
- Using a clip remover, disengage the clip and remove the rear door weatherstrip.
- HINT:
- Tape the clip remover tip before use.
| 12.
REMOVE REAR DOOR FRAME GARNISH
|
 |
- Disengage the clip and remove the rear door frame garnish.
| 13.
REMOVE REAR DOOR OUTSIDE STRIPE |
 |
Using a heat light, heat the rear door outside stripe.
- Heating temperature:
Item
|
Temperature
|
Vehicle Body
|
40 to 60°C (104 to 140°F)
|
- NOTICE:
- Do not heat the vehicle body excessively.
Pull back an edge of the rear door outside stripe and pull it parallel to the vehicle body to pull it off.
| 14.
REMOVE REAR DOOR LOWER OUTSIDE STRIPE |
 |
Using a heat light, heat the rear door lower outside stripe.
- Heating temperature:
Item
|
Temperature
|
Vehicle Body
|
40 to 60°C (104 to 140°F)
|
- NOTICE:
- Do not heat the vehicle body excessively.
Pull back an edge of the rear door lower outside stripe and pull it parallel to the vehicle body to pull it off.