SYSTEM DESCRIPTION
Troubleshooting · Vehicles built from Jun 2006
| WIPER AND WASHER SYSTEM |
The wiper and washer system may have the following function:
Function
Note
Raindrop Sensing
-
The windshield wiper relay assembly (auto wiper relay) controls the wiper system.
| RAINDROP SENSING FUNCTION |
General
The raindrop sensing function controls the wiper timing in accordance with the amount of raindrops that strike the windshield glass when the windshield wiper switch assembly is in the AUTO position.
The windshield wiper relay assembly (auto wiper relay) controls the wiper operation by calculating the optional wiping interval and speed in accordance with the following information:
- Rainfall data transmitted by the rain sensor.
- Taillight status signals transmitted by the main body ECU (whether it is day and night).
- Vehicle speed signals transmitted by the combination meter assembly.
- Set values regarding the system sensitivity transmitted by the automatic control adjuster.
- Rainfall data transmitted by the rain sensor.
Rain Sensor
The rain sensor consists of 2 LEDs (Light Emitting Diodes) that emit infrared rays, a photo diode that can receive those rays, a lens and rain sensor tape.


- HINT:
- If the windshield glass is being replaced, make sure to affix new rain sensor tape. Failure to do so will lead to a system malfunction.
- If no raindrops are present in the detection area, the infrared rays emitted by the LED are all reflected by the outer surface of the windshield glass and are received by the photo diode.
- If raindrops are present in the detection area, a portion of the emitted infrared rays passes through the windshield glass due to the change in the difference between the refractive indexes of the glass and the area outside the windshield glass (the refractive difference between air and water). The ability of the windshield glass to reflect light back inside is reduced by the presence of the rain. This change in the internal reflection due to the presence of the water reduces the proportion of the infrared rays that are received by the photo diode. The extent of this reduction is used to determine the amount of raindrops.

