PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
- HINT:
- Be sure to perform the SYMPTOM SIMULATION procedure before replacing the ECM. If these symptoms do not persist, the cause of the problem may be poor intermittent electrical contact (open or short) of a wire harness or connector.
| Symptom |
Suspected Area |
See page |
| Vehicle speed cannot be set. (The CRUISE main indicator light comes on.) |
1. Cruise control switch circuit |
Click here
|
| 2. Vehicle speed sensor circuit |
Click here
|
|
| 3. Combination meter |
Click here
|
|
| 4. Stop light switch |
Click here
|
|
| 5. Transmission range sensor circuit (A/T) |
Click here
|
|
| 6. Clutch switch circuit (M/T) |
Click here
|
|
| 7. If the symptoms still occur after the above ares have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| The cruise control is canceled while it is operating. |
1. Stop light switch circuit |
Click here
|
| 2. Clutch switch circuit (M/T) |
Click here
|
|
| 3. Transmission range sensor circuit (A/T) |
Click here
|
|
| 4. Cruise control switch circuit |
Click here
|
|
| 5. Vehicle speed sensor circuit |
Click here
|
|
| 6. Combination meter |
Click here
|
|
| 7. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| Vehicle speed cannot be set. (The CRUISE main indicator light does not come on.) |
1. Stop light switch circuit |
Click here
|
| 2. Clutch switch circuit (M/T) |
Click here
|
|
| 3. Vehicle speed sensor circuit |
Click here
|
|
| 4. Combination meter |
Click here
|
|
| 5. Cruise control switch circuit |
Click here
|
|
| 6. Transmission range sensor circuit (A/T) |
Click here
|
|
| 7. Cruise main indicator light circuit |
Click here
|
|
| 8. If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| Vehicle speed can be set. (The CRUISE main indicator light does not come on.) |
1. Cruise main indicator light circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Cruise control switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Pulling back on the control main switch does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
Replace ECM |
Click here
|
| The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light remains on.) |
1. Vehicle speed sensor circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| The cruise control is not canceled when vehicle speed drops below the low speed limit. (The CRUISE main indicator light goes off.) |
Replace ECM |
Click here
|
| Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Stop light switch circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Depressing the brake pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
Replace ECM |
Click here
|
| Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light remains on.) |
1. Clutch switch circuit (M/T) |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Depressing the clutch pedal does not cancel the cruise control. (The CRUISE main indicator light goes off.) |
Replace ECM |
Click here
|
| Moving the shift lever does not cancel the cruise control. |
1. Transmission range sensor circuit (A/T) |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|
|
| Hunting (Speed is not constant.) |
1. Vehicle speed sensor circuit |
Click here
|
| 2. Combination meter |
Click here
|
|
| 3. If the symptoms still occur after the above ares have been inspected and have proven to be normal, replace the ECM. |
Click here
|
|
| The CRUISE main indicator light remains blinking. |
1. TC and CG terminal circuit |
Click here
|
| 2. If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM. |
Click here
|