DATA LIST / ACTIVE TEST
System information · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| READ DATA LIST |
- HINT:
- Using the intelligent tester's DATA LIST allows switch, sensor, actuator, and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the DATA LIST according to the display on the tester.
ECM (Cruise control): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Actual vehicle speed
-
Memory Spd
Cruise control memorized speed / min.: 36 km/h (22.5 mph), max.: 200 km/h (125 mph)
Actual stored vehicle speed
-
Throttle
Throttle opening angle / min.: 0°, max.: 125°
Actual demanded throttle angle
-
Cruise Control
Cruise control system active condition / ON or OFF
ON: Cruise control activated
OFF: Cruise control deactivated
-
Main SW (Main)
Main switch signal (Main CPU) / ON or OFF
ON: Cruise control main switch on
OFF: Cruise control main switch off
"1"
CCS Ready M
Cruise control system standby condition (Main CPU) / ON or OFF
ON/OFF : ON/OFF changes each time main switch is pushed in
-
CCS Indicator M
Cruise indicator signal (Main CPU) / ON or OFF
ON: "CRUISE" on
OFF: "CRUISE" off
-
Cancel SW
CANCEL switch signal / ON or OFF
ON: CANCEL switch on
OFF: CANCEL switch off
-
SET/COAST SW
SET / COAST switch signal / ON or OFF
ON: - (COAST) / SET switch on
OFF: - (COAST) / SET switch off
-
RES/ACC SW
RES / ACC switch signal / ON or OFF
ON: + (ACCEL) / RES (RESUME) switch on
OFF: + (ACCEL) / RES (RESUME) switch off
-
Stp Light SW M
Stop light switch signal (Main CPU) / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
CCS Oper Status
PNP switch signal (D position) / ON or OFF
ON: Shift lever in D
OFF: Shift lever not in D
-
Clutch switch signal / ON or OFF
ON: Clutch pedal released
OFF: Clutch pedal depressed
-
- HINT:
- "1" is OK but CRUISE main indicator light does not illuminate → CRUISE main indicator light, wire harness, or ECM failure
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's ACTIVE TEST allows relays, VSVs, actuators, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Perform the ACTIVE TEST according to the display on the tester.
- HINT:
- The ignition switch must be turned on (IG) to perform the ACTIVE TEST using the intelligent tester.
Combination meter: Tester Display
Test Part
Control Range
Normal Condition
Indicat. Lamp Cruise
CRUISE main indicator light
Indicator light BLINK / OFF
-