2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT

    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN Communication System is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output.

      HINT:
      Refer to the DTC CHECK / CLEAR (Click here).

    2. Delete the DTCs.

    3. Recheck for DTCs. Based on the DTCs output above, try to force output of the A/C system DTC by simulating the operation indicated by the DTC.

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the PROBLEM SYMPTOMS TABLE (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. ACTUATOR CHECK (Click here for Automatic A/C)

    2. DATA LIST / ACTIVE TEST (Click here)

    3. TERMINALS OF ECU (Click here)

    4. ON-VEHICLE INSPECTION

    5. INSPECTION

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2006 – Sep 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009) →