Display does not Dim when Light Control Switch is Turned ON
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK DISPLAY SETTING |
 |
- Enter the display quality adjustment screen.
Turn the light control switch to the tail position.
Check if "Day Mode" on the display quality adjustment screen is on.
- OK:
- "Day Mode" is on.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| TURN "Day Mode" SETTING OFF |
|
| 2. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
 |
- Enter the "Vehicle Signal Check Mode" screen (Check Vehicle Signal) (Click here).
Check that the display changes between ON and OFF according to the light control switch operation.
- OK:
Light Control Switch
|
Display
|
Tail or on
|
ON
|
Off
|
OFF
|
- HINT:
- The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
- Result:
Result
|
Proceed to
|
NG
|
A
|
OK (for 2GR-FE RHD)
|
B
|
OK (except 2GR-FE RHD)
|
C
|
|
B |
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)
|
|
|
|
C |
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
|
|
|
| A |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|