Voice Recognition Difficulty
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK CONDITION |
 |
Check if the system voice recognition level is low when recognizing a particular voice.
- Result:
Result
|
Proceed to
|
System voice recognition level is low with any voice.
|
A
|
System voice recognition level is low only for a particular voice.
|
B
|
- HINT:
- System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. CHECK MAP DISC |
 |
- Check that the map disc is not deformed or cracked.
- OK:
- No deformations or cracks on the map disc
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK MAP DISC |
 |
- Check for dirt on the map disc surface.
- OK:
- No dirt is on the map disc surface.
- NOTICE:
- Do not use a conventional record cleaner or anti-static preservative.
- HINT:
- If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK MICROPHONE (OPERATION CHECK) |
 |
- Enter the "Microphone&Voice Recognition Check" screen (Check Mic & Voice Recognition) (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
Text in Illustration
*1
|
Microphone Input Level Meter
|
*2
|
Recording Switch
|
*3
|
Stop Switch
|
*4
|
Play Switch
|
*5
|
Recording Indicator
|
|
NG |
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
|