2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Cellular Phone cannot Send/Receive

Circuit diagnosis · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

INSPECTION PROCEDURE


1. CHECK "BLUETOOTH" SETTINGS
  1. Check if the "Bluetooth" settings are correct.

    OK:
    "Bluetooth" settings are correct.



NG
SET SETTINGS CORRECTLY
OK


2. CHECK CELLULAR PHONE
  1. Check if the cellular phone is "Bluetooth" compatible.

    HINT:
    Some versions of "Bluetooth" compatible cellular phones may not function.

    OK:
    The phone is "Bluetooth" compatible.



NG
END (ONLY A "BLUETOOTH" COMPATIBLE CELLULAR PHONE CAN BE USED)
OK


3. CHECK SETTINGS
  1. Check if the cellular phone functions.

    HINT:
    The cellular phone is unable to call under any of the following conditions:
    1. The cellular phone is locked.
    2. The directory is being transferred.
    3. The line is crossed.
    4. Transmission is regulated.
    5. The power is off.
    6. The cellular phone is not connected to "Bluetooth" ("BT" is displayed while connected).

      OK:
      None of the above conditions exist.



NG
SET CORRECTLY
OK


4. CHECK CELLULAR PHONE
  1. Check if the cellular phone can make a call.

    HINT:
    When the battery is low, calls cannot be made or received.

    OK:
    Cellular phone can make a call.



NG
REPAIR OR REPLACE CELLULAR PHONE
OK


5. CHECK RECEPTION
  1. Set the cellular phone so that it can receive calls.

  1. Place the cellular phone close to the navigation receiver assembly.

  1. Check if the cellular phone has reception according to the navigation receiver assembly.

    OK:
    Cellular phone has reception.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Cellular Phone Registration Failure, Phone Directory Transfer Failure (from Jun 2009)Cellular Phone cannot Send/Receive (from Jun 2009) →