2006-2011 Camry Aurion · Service Manual BODY

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Oct 2006


FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION
  1. The driver's seat is equipped with slide, reclining, lifter, front vertical and lumbar support adjustment functions.
  2. The memory system for the front seats is optional. With the memory function, the front power seat switch (position control ECU) performs the following: 1) controls the slide, reclining, lifter, and front vertical motors; 2) memorizes the seat position; and 3) performs the seat restoring operation.
  3. The memory call function uses the key ID code of the electrical key to memorize and reproduce the appropriate driving position for each individual who possesses an electrical key.

FUNCTION OF MAIN COMPONENT
The following functions are available:
Components
Function
Power seat motor assembly (slide motor)
Activated based on a signal from the position control ECU and slides the seat forward and rearward.
Power seat motor assembly (reclining motor)
Activated based on a signal from the position control ECU and tilts and reclines the seat.
Power seat motor assembly (front vertical motor)
Activated based on a signal from the position control ECU and raises and lowers the seat cushion front vertically.
Power seat motor assembly (lifter motor)
Activated based on a signal from the position control ECU and raises and lowers the seat cushion vertically.
Lumbar support adjuster motor
Activated based on a signal from the lumbar front power seat switch and adjusts the lumbar support.
Front power seat switch (reclining, lifter, slide, front vertical)
Based on switches operated, the seat adjuster signals are input in the position control ECU and the seat is adjusted accordingly.
Lumbar front power seat switch
Based on switches operated, the seat is adjusted accordingly.
Seat memory switch (driver side) (SET switch, memory switch)
When the SET switch and the SW1 or SW2 switch are pressed simultaneously, a signal is input to the outer mirror control ECU and sent to the position control ECU, which records the seat position and outer mirror position (RH and LH).
When the SW1 or SW2 switch is pressed, a signal is input to the outer mirror control ECU and sent to the position control ECU, which changes the seat position and outer mirror position (RH and LH) to each recorded position.

SYSTEM OPERATION
The front power seat adjustment and position memory are shown in the table below.
Seat Adjustment Function
Driver's Seat
Passenger Seat
Fore-and-Aft Slide
Power and memory
Power
Reclining
Power and memory
Power
Front Vertical Height
Power and memory
Power
Lifter
Power and memory
Power
Lumbar Support
Power
-
  1. For the driver side memory function, the memory switch operation is first transferred from the outer mirror control ECU to the front power seat switch RH (position control ECU) via the CAN communication line. Then, either the seat position is stored in memory or a previously stored seat position is recalled.
← SYSTEM DIAGRAM (from Oct 2006)HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2006 – May 2009) →