DISASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
REMOVE FUEL SENDER GAUGE ASSEMBLY |
 |
- Disconnect the fuel sender gauge connector.
- Unlock the fuel sender gauge, and slide it to remove.
| 2.
REMOVE FUEL NO. 1 TANK BAND BRACKET |
 |
- Using needle nozzle pliers, remove the E-ring.
- Disengage the 4 claws of the fuel No. 1 suction support and remove the fuel No. 1 tank band bracket from the fuel suction plate with the fuel filter.
Remove the spring from the fuel suction plate.
| 3.
REMOVE FUEL NO. 1 SUCTION SUPPORT |
 |
- Using a screwdriver with the tip taped, disengage the claw and remove the fuel No. 1 suction support.
| 4.
DISCONNECT FUEL PUMP HARNESS |
 |
- Disconnect the fuel pump harness connector from the fuel suction plate.
| 5.
REMOVE FUEL PUMP |
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and pull out the fuel pump from the fuel filter assembly.
- NOTICE:
- Do not damage the fuel pump filter.
- Do not remove the suction filter.
- Remove the fuel pump harness connector.
- Remove the O-ring from the fuel pump.
| 6.
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator from the fuel filter.
- Remove the 2 O-rings from the fuel pressure regulator.