INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1. INSTALL FRONT AIRBAG SENSOR |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
Install the front airbag sensor with the bolt.

- Torque:
- 17.5 N*m{ 179 kgf*cm , 13 ft.*lbf }
- NOTICE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
Check that there is no looseness in the installation parts of the front airbag sensor.
Connect the connector.
| 2. INSTALL ENGINE UNDER COVER LH |
| 3. INSTALL ENGINE UNDER COVER RH |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).
