2006-2011 Camry Aurion · Service Manual BODY

TERMINALS OF ECU

System information · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF CONTROL ECU)
B050671E38
  1. Disconnect the Q12 ECU connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    B (Q12-1) - E (Q12-2)
    B - W-B
    +B power supply
    Always
    10 to 14 V
    IG (Q12-5) - E (Q12-2)
    Y - W-B
    Ignition switch power supply
    Ignition switch off
    Below 1 V
    IG (Q12-5) - E (Q12-2)
    Y - W-B
    Ignition switch power supply
    Ignition switch ON
    10 to 14 V
    OPN (Q12-7) - E (Q12-2)
    BR - W-B
    Sliding roof motor open
    OPEN switch OFF
    10 kΩ or higher
    OPN (Q12-7) - E (Q12-2)
    BR - W-B
    Sliding roof motor open
    OPEN switch ON
    Below 1 Ω
    CLS (Q12-9) - E (Q12-2)
    L - W-B
    Sliding roof motor closed
    CLOSE switch OFF
    10 kΩ or higher
    CLS (Q12-9) - E (Q12-2)
    L - W-B
    Sliding roof motor closed
    CLOSE switch ON
    Below 1 Ω
    UP (Q12-10) - E (Q12-2)
    W - W-B
    Sliding roof motor up
    UP switch OFF
    10 kΩ or higher
    UP (Q12-10) - E (Q12-2)
    W - W-B
    Sliding roof motor up
    UP switch ON
    Below 1 Ω
    DWN (Q12-8) - E (Q12-2)
    G - W-B
    Sliding roof motor down
    DOWN switch OFF
    10 kΩ or higher
    DWN (Q12-8) - E (Q12-2)
    G - W-B
    Sliding roof motor down
    DOWN switch ON
    Below 1 Ω
    E (Q12-2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the Q12 ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    OPN (Q12-7) - E (Q12-2)
    BR - W-B
    Sliding roof motor open
    Ignition switch ON, sliding roof closed, OPEN switch OFF
    Below 1 V
    OPN (Q12-7) - E (Q12-2)
    BR - W-B
    Sliding roof motor open
    Ignition switch ON, sliding roof closed, OPEN switch ON
    10 to 14 V
    CLS (Q12-9) - E (Q12-2)
    L - W-B
    Sliding roof motor closed
    Ignition switch ON, sliding roof open, CLOSE switch OFF
    Below 1 V
    CLS (Q12-9) - E (Q12-2)
    L - W-B
    Sliding roof motor closed
    Ignition switch ON, sliding roof open, CLOSE switch ON
    10 to 14 V
    UP (Q12-10) - E (Q12-2)
    W - W-B
    Sliding roof motor up
    Ignition switch ON, sliding roof tilted downward, UP switch OFF
    Below 1 V
    UP (Q12-10) - E (Q12-2)
    W - W-B
    Sliding roof motor up
    Ignition switch ON, sliding roof tilted downward, UP switch ON
    10 to 14 V
    DWN (Q12-8) - E (Q12-2)
    G - W-B
    Sliding roof motor down
    Ignition switch ON, sliding roof tilted upward, DOWN switch OFF
    Below 1 V
    DWN (Q12-8) - E (Q12-2)
    G - W-B
    Sliding roof motor down
    Ignition switch ON, sliding roof tilted upward, DOWN switch ON
    10 to 14 V
    If the result is not as specified, the ECU may have a malfunction.

← PROBLEM SYMPTOMS TABLE (from Oct 2006)TERMINALS OF ECU (from Oct 2006) →