Tachometer Malfunction
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The meter CPU receives engine revolution signals from the ECM via the CAN communication lines (CAN No. 1 Bus). The meter CPU displays engine revolution data that is calculated based on the data received from the ECM.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTC is output (Click here for LHD, Click here for RHD).
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN communication DTC is output.
B (Click here for LHD, Click here for RHD)
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the values in the table below.
Combination Meter: Tester Display
Test Part
Control Range
Diagnostic Note
Tacho Meter Operation
Tachometer
0, 1,000, 2,000, 3,000, 4,000, 5,000, 6,000, 7,000 (rpm)
-
- OK:
- Needle indication is normal.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Data List.
Check the operation by referring to the values in the table below.
Combination Meter: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Rpm
Engine speed/Min.: 0 rpm, Max.: 12,800 rpm
Almost same as actual engine speed (When engine is running)
If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.
- OK:
- Engine speed displayed on the tester is almost the same as the actual engine speed.
|
|
||||
| OK | ||
| ||
| 4. READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Power train / Engine / Data List.
Check the values by referring to the table below.
Engine: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Speed
Engine speed/Min.: 0 rpm, Max.: 16,383.75 rpm
Almost same as actual engine speed (When engine is running)
-
- OK:
- Engine speed displayed on the tester is almost the same as the actual engine speed.
|
|
||||
| OK | |
| 5. REPLACE ECM |
Replace the ECM with a new or a normal one.
- OK:
- The operation of the tachometer returns to normal.
|
|
||||
| OK | ||
| ||
