The air conditioning harness connects the air conditioning amplifier and each servo motor. The air conditioning amplifier supplies power and sends operation instructions to each servo motor through the air conditioning harness. Each servo motor sends the damper position information to the air conditioning amplifier.
DTC No.
DTC Detection Condition
Trouble Area
B1497/97
Communication line error or open
Air conditioning harness
A/C amplifier
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR
Remove the A/C amplifier.
Disconnect the connector from the A/C amplifier.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E38-14 (GND) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. INSPECT AIR CONDITIONING AMPLIFIER
Reconnect the connector to the A/C amplifier.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
e1-2 (BUS G) - E38-14 (GND)
Always
Below 1 Ω
NG
REPLACE AIR CONDITIONING AMPLIFIER
OK
3. INSPECT AIR CONDITIONING AMPLIFIER
Disconnect the connector (e1) from the A/C amplifier.
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
e1-4 (B BUS) - Body ground
Ignition switch off
Below 1 V
e1-4 (B BUS) - Body ground
Ignition switch on (IG)
10 to 14 V
NG
REPLACE AIR CONDITIONING AMPLIFIER
OK
4. REPLACE AIR CONDITIONING HARNESS
Replace the air conditioning harness.
HINT:
Since the air conditioning harness cannot be inspected while it is removed from the vehicle, replace the air conditioning harness with a normal one and check that the condition returns to normal.