2006-2011 Camry Aurion · Service Manual TRANSMISSION

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK DTC

  1. B139188E02
    DTCs which are stored in the ECM can be displayed with the intelligent tester and generic OBD scan tool.
    These scan tools can display pending DTCs and current DTCs. Some DTC aren't stored if the ECM doesn't detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.

    1. Connect the intelligent tester to the Data Link Connector 3 (DLC3).

    2. Turn the ignition switch to the ON position.

    3. Enter the following menus: Enter / Powertrain / ECT / DTC / Current (or Pending).

    4. Confirm the DTCs and freeze frame data and then write them down.

    5. Confirm the details of the DTCs (Click here).

      NOTICE:
      When simulating a symptom with the scan tool to check the DTCs, use normal mode. For codes on DIAGNOSTIC TROUBLE CODE CHART which are subject to "2-trip detection logic", perform the following actions.

      Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process again. When the problem has been simulated twice, the MIL illuminates and the DTCs are recorded in the ECM.


CLEAR DTC WITH INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Enter the following menus: Enter / Powertrain / ECT / DTC / Clear.

← DIAGNOSIS SYSTEM (from Jun 2009)DTC CHECK / CLEAR (from Jun 2009) →