2006-2011 Camry Aurion · Service Manual TRANSMISSION

INITIALIZATION

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


RESET TRANSAXLE COMPENSATION CODE

NOTICE:
  1. If the following parts have been replaced, initialize the TCM and perform a road test to allow the TCM to learn.
    1. Valve body assembly
    1. Shift solenoid SL3
    1. Shift solenoid SL4
  1. The transaxle compensation code can be reset only with the intelligent tester.

HINT:
The TCM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or TCM has been replaced, it is necessary to reset the memory so that the TCM can memorize the new information.
Reset procedure is as follows:

  1. Shift the shift lever to the N or P position.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

  5. C122793
    Enter the menu items in this order: Powertrain / ECT / Utility / A/T Code Reset.

  6. Press "Next".

  7. C122794
    Press "Next" again to proceed.

    CAUTION:
    After the transaxle compensation code is reset, be sure to perform a road test to allow the TCM to learn.

  8. C122804
    Press "Exit".


PERFORM ROAD TEST TO ALLOW TCM TO LEARN

NOTICE:
Perform the following procedures while strictly observing all traffic laws and speed limits.

  1. Warm up the engine.

  2. From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.

  3. Repeat the previous step until shift shock no longer occurs.

  4. From a standstill, achieve highest possible speed with the accelerator pedal opened 25% or more. Keep the accelerator pedal angle steady while driving the vehicle.

  5. Repeat the previous step until shift shock no longer occurs.


RESET MEMORY

NOTICE:
  1. Perform the RESET MEMORY (AT initialization) when replacing the engine assembly.
  2. The RESET MEMORY can be performed only with the intelligent tester.

HINT:
The TCM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly or TCM has been replaced, it is necessary to reset the memory so that the TCM can memorize the new information.

  1. Reset procedure is as follows:

    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch on (IG).

    4. Turn the intelligent tester main switch on.

    5. Select the following items: "Powertrain / ECT / Reset Memory".
      C121707E01

      NOTICE:
      After performing the RESET MEMORY, be sure to perform the ROAD TEST (Click here) described earlier.

← INITIALIZATION (Oct 2006 – May 2009)MONITOR DRIVE PATTERN (from Oct 2006) →