P0724 Brake Switch "B" Circuit High
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling while driving in lock-up condition when brakes are suddenly applied.When the brake pedal is depressed, this switch sends a signal to the TCM. Then the TCM cancels the operation of the lock-up clutch while braking is in progress.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0724 |
The stop light switch remains ON even when the vehicle is driven in a STOP (less than 3 km/h (2 mph)) and GO (30 km/h (19 mph) or more) fashion 5 times (2-trip detection logic). |
|
MONITOR DESCRIPTION
This DTC indicates that the stop light switch remains ON. When the stop light switch remains ON during "stop and go" driving, the TCM interprets this as a fault in the stop light switch circuit, illuminates the MIL, and stores the DTC. The vehicle must stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) 5 times for 2 consecutive driving cycles in order to set this DTC.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING DATA LIST (STP SIGNAL) |
- HINT:
- According to the Data List displayed on the intelligent tester, you can read the value of switches, sensors, actuators and other items without removing any parts. Reading the Data List as the first step in troubleshooting is one method to save diagnostic time.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn on the tester.
Enter the following items: "Powertrain / ECT / Data List".
According to the display on the tester, read "Data List".
- Standard:
Tester Display
Measurement Item/Range
Normal Condition
Stop Light Switch
Stop light switch status/
ON or OFF
- Brake pedal is depressed: ON
- Brake pedal is released: OFF
- Brake pedal is depressed: ON
- NOTICE:
- In the table above, the conditions listed under "Normal Condition" are reference conditions. Do not depend solely on these reference conditions when deciding whether a part is faulty.
|
|
||||
| NG | |
| 2. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Remove the stop light switch assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Switch Position
Tester Connection
Specified Condition
Switch pin free
1 - 2
Below 1 Ω
Switch pin pushed in
1 - 2
10 kΩ or higher
Switch pin free
3 - 4
10 kΩ or higher
Switch pin pushed in
3 - 4
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - TCM) |
Install the stop light switch assembly.

Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
- Standard voltage:
Condition
Tester Connection
Specified Condition
Brake pedal is depressed
C56-12 (STP) - Body ground
10 to 14 V
Brake pedal is released
C56-12 (STP) - Body ground
Below 1 V
|
|
||||
| OK | ||
| ||
