REASSEMBLY
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| 1.
INSTALL IGNITION OR STARTER SWITCH ASSEMBLY |
 |
- Engage the 2 claws to install the ignition or starter switch assembly to the steering lock sub-assembly.
| 2.
INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle) |
 |
- Install the key interlock solenoid to the steering lock sub-assembly with the 2 screws.
| 3.
INSTALL UN-LOCK WARNING SWITCH ASSEMBLY |
 |
- Engage the 2 claws to install the un-lock warning switch assembly to the steering lock sub-assembly.
| 4.
INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
 |
Make sure that the ignition switch lock cylinder assembly is in the ACC position.
- Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.
Make sure that the ignition switch lock cylinder assembly is securely installed.
| 5.
INSPECT STEERING LOCK OPERATION
|
 |
- Check that the steering lock mechanism is activated when the key is removed.
- Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
- HINT:
- If there is any abnormality, replace the ignition switch lock cylinder assembly.
| 6.
INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY |
 |
Temporarily install the assembled steering lock and its bracket to the steering column assembly with 2 new tapered-head bolts.
- Tighten the 2 tapered-head bolts until the bolt heads break off.
| 7.
INSTALL TRANSPONDER KEY AMPLIFIER |
 |
Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.
- Push the transponder key amplifier to install it to the upper bracket.
- NOTICE:
- Do not push the amplifier with excessive force.