Skid Control ECU Communication Stop Mode
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Skid Control ECU Communication Stop Mode |
|
|
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
- HINT:
- Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
- without VSC:
Tester Connection
Condition
Specified Condition
A25-26 (CANH) - A25-15 (CANL)
Ignition switch off
54 to 69 Ω
- with VSC:
Tester Connection
Condition
Specified Condition
A26-35 (CANH) - A26-14 (CANL)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (IG1, GND1, GND2) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
- without VSC:
Tester Connection
Condition
Specified Condition
A25-4 (GND1) - Body ground
Always
Below 1 Ω
A25-1 (GND2) - Body ground
Always
Below 1 Ω
- with VSC:
Tester Connection
Condition
Specified Condition
A26-4 (GND1) - Body ground
Always
Below 1 Ω
A26-1 (GND2) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
- without VSC:
Tester Connection
Condition
Specified Condition
A25-18 (IG1) - Body ground
Ignition switch on
10 to 14 V
- with VSC:
Tester Connection
Condition
Specified Condition
A26-28 (IG1) - Body ground
Ignition switch on
10 to 14 V
|
|
||||
| OK | ||
| ||
