Driver Side Door UNLOCK Detection Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The driver's door unlock detection switch is built into the driver's door lock assembly. The switch turns on when the driver's door is locked and turns off when the door is unlocked.The main body ECU (instrument panel J/B) is connected to the driver's door lock assembly via terminal LSWD and driver's door lock/unlock state signals are input to the main body ECU (instrument panel J/B).
The main body ECU (instrument panel J/B) applies voltage to the door unlock detection switch via terminal LSWD. When the door unlock detection switch is on (there is continuity between the switch terminals), a lock state signal is input to the main body ECU (instrument panel J/B). When the switch is off (there is no continuity between the switch terminals), an unlock state signal is input.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.


Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select D-Door Lock Pos SW in the DATA LIST and read the tester display.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D-Door Lock Pos SW
Driver side door unlock detection switch signal / ON or OFF
ON: Driver side door is unlocked
OFF: Driver side door is locked
-
- OK:
- The display is as specified in the "Normal Condition" column.
|
|
||||
| OK | ||
| ||
| 2. INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR UNLOCK DETECTION SWITCH) |
Remove the front door lock assembly (driver side) (Click here).


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Measurement Condition
Door Lock Condition
Specified Condition
7 - 8
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
10 kΩ or higher
7 - 8
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK ASSEMBLY - MAIN BODY ECU) |
Disconnect the main body ECU (instrument panel J/B) connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- for LHD:
Tester Connection
(Symbols)
Condition
Specified Condition
I7-8 (LSSR) - E7-9 (LSWD)
Always
Below 1 Ω
I7-8 (LSSR) - Body ground
Always
10 kΩ or higher
I7-7 (E) - Body ground
Always
Below 1 Ω
- for RHD:
Tester Connection
(Symbols)
Condition
Specified Condition
H8-7 (LSSR) - E7-9 (LSWD)
Always
Below 1 Ω
H8-7 (LSSR) - Body ground
Always
10 kΩ or higher
H8-8 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
