TERMINALS OF ECU
System information · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| CHECK REAR SUNSHADE RELAY |


Disconnect the N41 relay connector.
Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction in the wire harness side connector.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
IG (N41-1) - E (N41-7)
R - W-B
Power source (IG)
Ignition switch OFF
Below 1 V
IG (N41-1) - E (N41-7)
R - W-B
Power source (IG)
Ignition switch ON
10 to 14 V
SW (N41-5) - E (N41-7)
W - W-B
Rear sunshade switch signal
Ignition switch ON, rear sunshade switch OFF
10 kΩ or higher
SW (N41-5) - E (N41-7)
W - W-B
Rear sunshade switch signal
Ignition switch ON, rear sunshade switch ON
Below 1 Ω
E (N41-7) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Connect the N41 relay connector.
Measure the voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction in the wire harness side connector.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
REV (N41-2) - Body ground
R - Body ground
Reverse signal
Ignition switch ON, shift lever not in R
Below 1 V
REV (N41-2) - Body ground
R - Body ground
Reverse signal
Ignition switch ON, shift lever in R
10 to 14 V
SW (N41-5) - Body ground
W - Body ground
Rear sunshade switch signal
Ignition switch ON, rear sunshade switch not pushed
10 to 14 V
SW (N41-5) - Body ground
W - Body ground
Rear sunshade switch signal
Ignition switch ON, rear sunshade switch pushed
Below 1.5 V