2006-2011 Camry Aurion · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2009


INSPECT ENGINE SWITCH

  1. Measure the resistance according to the value(s) in the table below.

    A109252E01

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS1) - 5 (GND)
    Pushed
    Below 1 Ω
    2 (SS2) - 5 (GND)
    Pushed
    Below 1 Ω
    7 (SS1) - 5 (GND)
    Not pushed
    10 kΩ or higher
    2 (SS2) - 5 (GND)
    Not pushed
    10 kΩ or higher

    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    A109252E71

    Standard Resistance:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    (Engine Switch Illumination)
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    (Indicator Light)
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    (Indicator Light)

    If the result is not as specified, replace the engine switch.

← REMOVAL (from Jun 2009)INSTALLATION (from Jun 2009) →