The skid control buzzer sounds and the SLIP indicator light blinks during VSC operation.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
Connect the intelligent tester to the DLC3.
Select the "Active Test" on the intelligent tester (Click here).
Active Test: ABS/TRC/VSC
Tester Display
Test Part
Control Range
Diagnostic Note
Buzzer
Skid control buzzer
Buzzer ON/OFF
Buzzer can be heard
Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.
Result:
Result
Proceed to
Buzzer does not sound or sounds constantly
A
Buzzer sounds/stops
B
B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A
2. INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)
Disconnect the skid control buzzer connector.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
E13-2 - Body ground
Ignition switch on (IG)
10 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK
3. INSPECT SKID CONTROL BUZZER
Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.