2006-2011 Camry Aurion · Service Manual BRAKE

VSC Warning Light does not Come ON

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009

DESCRIPTION

The skid control ECU communicates with the combination meter assembly via CAN communication. If the ECU stores a DTC, the master caution indicator light will illuminate, and the DTC will be displayed on the multi-information display in the combination meter (models with multi-information display). On models without a multi-information display, the VSC warning light will come on when the skid control ECU stores a DTC.

WIRING DIAGRAM

C225724E03
C225724E04

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS/TRC/VSC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC Warning Lamp
    VSC warning light
    Warning light ON/OFF
    Observe combination meter

  1. Check that "ON" and "OFF" of the VSC warning light/multi information display are indicated on the combination meter assembly when using the intelligent tester.

    OK:
    The VSC warning light/multi information display turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← VSC Warning Light does not Come ON (Jun 2006 – Sep 2006)Brake Warning Light Remains ON (Jun 2006 – Sep 2006) →