2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedures to troubleshoot the smart entry and start system.
  2. The intelligent tester can be used in steps 4 and 6.
  3. When troubleshooting the smart entry and start system using the intelligent tester with the engine switch off, connect the intelligent tester to the vehicle and repeat turning any of the courtesy light switches on and off until communication between the tester and the vehicle begins (the interval between ON and OFF should be less than 1.5 sec.).


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:
      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency
      Where
      Road conditions
      Under what conditions?
      Driving conditions, weather conditions
      How did it happen?
      Problem symptoms

    NEXT

    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      (ECU connected, communication line malfunctioning) DTC is not output.
      A
      (ECU connected, communication line malfunctioning) DTC is output.
      B
      (Click here for LHD with Smart Entry and Start System)
      (Click here for RHD with Smart Entry and Start System)


    B.
    A

    5.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table.
      A
      Fault is listed in problem symptoms table.
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. ON-VEHICLE INSPECTION (Click here)

    2. DATA LIST/ACTIVE TEST (Click here)

    3. TERMINALS OF ECU (Click here)

    NEXT

    7.REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2006 – May 2009)CUSTOMIZE PARAMETERS (from Oct 2006) →