2006-2011 Camry Aurion · Service Manual STEERING

Unlock Position Sensor Signal Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The unlock position sensor is one of the components in the steering lock actuator. The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the main body ECU. Receiving the signal, the ECU permits engine start. (This prevents the engine from being started with the steering locked.)

WIRING DIAGRAM

C113485E04

INSPECTION PROCEDURE


1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)

  1. C106483E23
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E51-4 (SLP1) - E51-2 (SGND)
    1. Engine switch off
    2. Engine switch on (ACC or IG)
    Below 1 V



OK
CHECK SMART ENTRY AND START SYSTEM FUNCTION
NG


2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU)

  1. C113502E02
    Disconnect the E51 connector from the steering lock actuator assembly.

  1. Disconnect the E7 connector from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E51-4 (SLP1) - E7-18 (SLP)
    Always
    Below 1 Ω
    E51-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Steering Lock Motor Drive Power Circuit (from Oct 2006)Power Source Circuit (from Oct 2006) →