REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
DISCHARGE FUEL SYSTEM PRESSURE |
 |
- HINT:
-
Click here.
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
|
 |
- Disconnect the mass air flow meter connector (*1).
Disconnect the purge VSV connector (*2).
Disconnect the 2 purge VSV vacuum hoses (*3).
Disconnect the purge line hose from the clamp (*4).
- Disconnect the No. 2 ventilation hose from the air cleaner hose.
- Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.
- Remove the 2 bolts and air cleaner cap.
Remove the air cleaner filter element from the air cleaner case.
| 4.
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
|
 |
- Remove the 2 nuts and cover.
| 5.
DISCONNECT FUEL TUBE SUB-ASSEMBLY |
 |
- Remove the No. 1 fuel pipe clamp.
- NOTICE:
- Check for foreign matter on the pipe and around the connector before disconnecting the quick connector. Clean the connector if necessary.
- If the connector and pipe are stuck, pinch the connector, and push and pull the pipe to disconnect them.
- NOTICE:
- Do not use any tools in this procedure.
- Check for foreign matter on the sealing surface of the disconnected pipe. Clean it if necessary.
- Separate the fuel tube sub-assembly from the fuel hose clamp.
| 6.
DISCONNECT NO. 2 VENTILATION HOSE |
 |
- Disconnect the No. 2 ventilation hose from the ventilation valve.
| 7.
REMOVE FUEL DELIVERY PIPE WITH INJECTOR |
 |
- Remove the 2 wire harness clamps.
Disconnect the 4 fuel injector connectors.
- Remove the 2 bolts, then remove the fuel delivery pipe together with the 4 fuel injectors.
- NOTICE:
- Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
- Remove the 2 delivery pipe spacers from the cylinder head.
Remove the 4 insulators from the cylinder head.
| 8.
REMOVE FUEL INJECTOR ASSEMBLY |
 |
- Pull out the 4 injectors from the delivery pipe.
Remove the 4 O-rings from the injectors.