2006-2011 Camry Aurion · Service Manual ENGINE

B2286 Runnable Signal Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

DESCRIPTION

This DTC is output when serial communication signals and CAN communication signals in the circuit between the main body ECU (instrument panel junction block assembly) and ECM are inconsistent.
DTC No.
DTC Detection Condition
Trouble Area
B2286
Serial communication signals and CAN communication signals in the circuit between the main body ECU (instrument panel junction block assembly) and ECM are inconsistent.
  1. CAN communication system
  2. ECM
  3. Main body ECU (instrument panel junction block assembly)
  4. Wire harness or connector

WIRING DIAGRAM

B233095E01

INSPECTION PROCEDURE

HINT:
When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block assembly) is replaced, perform the registration procedures for the engine immobiliser system.


1. CHECK OPERATION OF TACHOMETER
  1. Run the engine and check if the function of the tachometer in the combination meter is normal.

    OK:
    Actual engine revolution speed and the revolution indicated on the tachometer are the same.



NG
Go to step 3
OK


2. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Clear the DTCs (Click here).

  1. Check for CAN communication system DTC (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK

GO TO COMBINATION METER SYSTEM

3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - ECM)
  1. Disconnect the A24 connector.

  1. Disconnect the E8 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E8-8 (TACH) - A24-15 (TACH)
    Always
    Below 1 Ω
    E8-8 (TACH) or A24-15 (TACH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) - ECM)
OK


4. READ VALUE USING INTELLIGENT TESTER
  1. Reconnect the connectors.

  1. Connect the intelligent tester to the DLC3.

  1. Check the Data List for proper functioning of the engine.

    HINT:
    When using the intelligent tester with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    E/G Cond
    Engine condition/STOP or RUN
    STOP: Engine is stopped
    RUN: Engine is running
    -

    OK:
    STOP (engine is stopped) and RUN (engine is running) appear on the screen.



NG
REPLACE ECM (Click here)
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


← B2285 Steering Lock Position Signal Circuit Malfunction (from Jun 2009)B2287 LIN Communication Master Malfunction (from Jun 2009) →