2006-2011 Camry Aurion · Service Manual ENGINE

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Jun 2009


DESCRIPTION
  1. Push-button start function data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the function seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
H100769E16
E138501E02

HINT:
The ECU uses ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

Tester Connection
Terminal Description
Condition
Specified Condition
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
CAN bus line
Engine Switch OFF*
56 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Engine Switch OFF*
200 Ω or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Engine Switch OFF*
200 Ω or higher
CANH (6) - BAT (16)
HIGH-level CAN bus line
Engine Switch OFF*
6 kΩ or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Engine Switch OFF*
6 kΩ or higher

NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches or the doors.

HINT:
Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
  2. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.


INSPECT BATTERY VOLTAGE
If the voltage is below 11 V, recharge or replace the battery before proceeding.

Standard Voltage:
11 to 14 V

← TERMINALS OF ECU (from Jun 2009)DTC CHECK / CLEAR (from Jun 2009) →