2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE VALVE LIFTER

  1. A062842E01
    Remove the valve lifters.

    HINT:
    Arrange the valve lifters in the correct order.


2. REMOVE INTAKE VALVE

  1. A128225E01
    Using SST and wooden blocks, compress and remove the valve retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE EXHAUST VALVE

  1. A128226E01
    Using SST and wooden blocks, compress and remove the valve retainer locks.
    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


4. REMOVE VALVE STEM OIL SEAL

  1. A013356E04
    Using needle-nose pliers, remove the oil seals.


5. REMOVE VALVE SPRING SEAT

  1. A062845E01
    Using compressed air and a magnetic finger, remove the valve spring seats by blowing air onto them.


6. REMOVE NO. 1 STRAIGHT SCREW PLUG

  1. A062841
    Using a 14 mm straight hexagon wrench, remove the 2 screw plugs and 2 gaskets.

    NOTICE:
    If water leaks from the straight screw plug or the plug corrodes, replace it.


7. REMOVE STUD BOLT

8. REMOVE RING PIN

9. REMOVE INTAKE VALVE GUIDE BUSH
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on wooden blocks.

  1. A036632E01
    Using SST and a hammer, tap out the guide bush.
    SST
    09201-10000   (09201-01050)
    09950-70010   (09951-07100)


10. REMOVE EXHAUST VALVE GUIDE BUSH
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on wooden blocks.

  1. A036633E03
    Using SST and a hammer, tap out the guide bush.
    SST
    09201-10000   (09201-01050)
    09950-70010   (09951-07100)

← REMOVAL (from Jun 2009)INSPECTION (Jun 2006 – Sep 2006) →