2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. SEPARATE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

HINT:
Click here.


2. SEPARATE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

HINT:
Click here.


3. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

  1. A126932E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A091018
    Remove the 8 bolts, rear spacer, drive plate and front spacer.


4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

  1. D008941E02
    Put matchmarks on the clutch cover assembly and flywheel sub-assembly.

  1. Loosen the 6 bolts one turn at a time until spring tension is released.

  1. Remove the 6 bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.


5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.


6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

  1. A126932E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A091020E01
    Remove the 8 bolts and flywheel.


7. REMOVE ENGINE REAR OIL SEAL

  1. A128873E01
    Using a knife, cut through the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Jun 2006 – Sep 2006) →