INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
|
 |
- Install the spring and check ball body.
- Align the groove of the manual valve with the pin of the lever.
Install the valve body with the 17 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
- NOTICE:
- Push the valve body against the accumulator piston spring and the check ball body to install it.
- First, temporarily tighten the bolts marked by (1) in the illustration because they are positioning bolts.
- Bolt length:
- Bolt A: 25 mm (0.984 in.)
Bolt B: 57 mm (2.244 in.)
Bolt C: 41 mm (1.614 in.)
| 2.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
|
 |
- Coat a new O-ring with ATF.
Install the O-ring to the oil strainer.
- Install the oil strainer with the 3 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
| 3.
INSTALL TRANSMISSION WIRE
|
 |
- Coat the O-ring with ATF.
Install the ATF temperature sensor with the lock plate and bolt.
-
Torque:
- 6.6 N*m{
67 kgf*cm
, 58 in.*lbf
}
Connect the 7 shift solenoid valve connectors.
| 4.
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
|
 |
- Install the 2 magnets in the oil pan.
Apply adhesive or equivalent to 18 bolts.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.
-
Torque:
- 7.8 N*m{
79 kgf*cm
, 69 in.*lbf
}
- NOTICE:
- Since the bolts should be seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.
| 5.
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
 |
- HINT:
-
Click here.