2006-2011 Camry Aurion · Service Manual TRANSMISSION

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK SHIFT LOCK OPERATION
  1. Move the shift lever to the P position.

  1. Turn the ignition switch to the LOCK position.

  1. Check that the shift lever cannot be moved to any position other than P.

  1. Turn the ignition switch to the ON position, depress the brake pedal and check that the shift lever can be moved to another position. If operation cannot be done as specified, inspect the shift lock control unit.


CHECK SHIFT LOCK RELEASE BUTTON OPERATION
  1. Using a screwdriver, remove the shift lock release cover.

  1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.
    If operation cannot be done as specified, check the shift lever assembly installation condition.


CHECK KEY INTERLOCK OPERATION
  1. Turn the ignition switch to the ON position.

  1. Depress the brake pedal and move the shift lever to any position other than P.

  1. Check that the ignition key cannot be turned to the LOCK position.

  1. Move the shift lever to the P position, turn the ignition key to the LOCK position and check that the ignition key can be removed.
    If operation cannot be done as specified, inspect the shift lock control unit.


INSPECT SHIFT LOCK CONTROL ECU

  1. C127833E12
    Measure the voltage according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.


    Standard voltage:
    Terminal
    Measuring Condition
    Voltage (V)
    6 (ACC) - 1 (E)
    Ignition switch ON
    11 to 14
    6 (ACC) - 1 (E)
    Ignition switch ACC
    11 to 14
    6 (ACC) - 1 (E)
    Ignition switch off
    Below 1
    4 (STP) - 1 (E)
    Depress brake pedal
    11 to 14
    4 (STP) - 1 (E)
    Release brake pedal
    Below 1
    5 (KLS+) - 1 (E)
    1. 1. Ignition switch ACC and shift lever P position
    2. 2. Ignition switch ACC and shift lever except P position
    3. 3. Ignition switch ACC and shift lever P position (After approx. 1 second)
    1. 7.5 to 11
    2. Below 1
    3. 6 to 9
    8 (IG) - 1 (E)
    Ignition switch ON
    10 to 14
    8 (IG) - 1 (E)
    Ignition switch off
    Below 1

  1. C127833E12
    Measure the resistance according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.


    Standard resistance:
    Terminal
    Measuring Condition
    Specified Value
    1 (E) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, replace the shift lock control ECU.

← INSTALLATION (from Jun 2009)ON-VEHICLE INSPECTION (from Jun 2009) →