Removal / installation · Vehicles built from Jun 2006
1.
ADJUST SHIFT LEVER POSITION
Move the shift lever to the N position.
Remove the nut from the control shaft lever.
Disconnect the transmission control cable assembly from the control shaft lever.
Push the control shaft fully downward.
Return the control shaft lever 2 notches to the N position.
Move the slider in the directions indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.
NOTICE:
Do not damage the boot.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque:
15 N*m{
153 kgf*cm
, 11 ft.*lbf
}
NOTICE:
Do not damage the boot.
Push in the lock piece.
NOTICE:
Firmly push in the lock piece until the slider lock is engaged.
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.