2006-2011 Camry Aurion · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from Oct 2006


1. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to the N position.

  1. C132236
    Remove the nut and transmission control cable assembly from the control shaft lever.

  1. C135733E02
    Align the protrusions of the park/neutral position switch.

  1. C135734E02
    Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.

    NOTICE:
    Do not damage the boot.

  1. C132236
    Connect the transmission control cable assembly to the control shaft lever with the nut.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. C138300E01
    Push in the lock piece.

    NOTICE:
    Firmly push in the lock piece until the slider lock is engaged.

  1. Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.

← INSPECTION (from Oct 2006)REASSEMBLY (from Oct 2006) →