2006-2011 Camry Aurion · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. D003654E01
    Using SST and a hammer, install a new oil seal to the oil pump body.
    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.


2. INSTALL FRONT OIL PUMP BODY O-RING

  1. C055817E04
    Coat a new O-ring with ATF, and install it to the oil pump body.

    NOTICE:
    1. Make sure that the O-ring is not twisted or pinching.
    2. Apply enough ATF to the O-ring prior to installation.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. D009206E14
    Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side up.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D009206E15
    Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.


5. INSTALL STATOR SHAFT ASSEMBLY

  1. D003651E01
    Align the bolt holes in the stator shaft assembly with those in the front oil pump and gear body sub-assembly.

  1. Using a torx socket (T30), install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }


6. INSTALL CLUTCH DRUM OIL SEAL RING

  1. D026627E01
    Coat 2 new clutch drum oil seal rings with ATF.

  1. Install the 2 clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.

← INSPECTION (from Jun 2006)INSTALLATION (from Jun 2006) →