REASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
INSTALL UNDERDRIVE PLANETARY RING GEAR |
 |
- Install a new snap ring to the outer race of the tapered roller bearing.
- HINT:
- If replacing the bearing, also replace the counter driven gear with a new one.
- Using a piston ring compressor, squeeze the snap ring.
- Using SST and a press, press in the outer race of the angular ball bearing.
- SST
- 09950-60020
(09951-00890)
09950-70010
(09951-07100)
- NOTICE:
- Do not damage the snap ring during installation of the outer race.
- Install the underdrive planetary ring gear to the counter driven gear.
- Using snap ring pliers, install the snap ring.
| 2.
INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY |
 |
- Using a press, press the angular ball bearing inner race (rear side) into the underdrive planetary gear.
- SST
- 09950-60010
(09951-00260)
09950-70010
(09951-07100)
09726-40010
- Install the counter driven gear with planetary ring gear to the underdrive planetary gear.
- Using SST and a press, press in the angular ball bearing inner race (front side).
- SST
- 09950-60010
(09951-00260)
09950-70010
(09951-07100)
09726-40010
- NOTICE:
- Press the counter driven gear while rotating it.
- Using a press, press in the parking lock gear.
- SST
- 09950-60010
(09951-00260)
09950-70010
(09951-07100)
09316-20011
- NOTICE:
- Press the counter driven gear while rotating it.
| 3.
INSTALL DIFFERENTIAL DRIVE PINION |
 |
- Using a press, press in the differential drive pinion.
- SST
- 09726-40010
09950-60010
(09951-00260)
09950-70010
(09951-07100)
- NOTICE:
- Press the counter driven gear while rotating it.
| 4.
INSTALL CYLINDRICAL ROLLER BEARING RACE INNER |
 |
- Using a press, press in the cylindrical roller bearing race inner.
- SST
- 09515-21010
09950-60010
(09951-00260)
09950-70010
(09951-07100)
- NOTICE:
- Press the counter driven gear while rotating it.
| 5.
INSTALL FRONT PLANETARY GEAR NUT |
 |
- Clamp the underdrive planetary gear in a soft jaw vise.
- NOTICE:
- Be careful not to damage the differential drive pinion.
Using a socket wrench, install a new lock nut.
-
Torque:
- 280 N*m{
2,855 kgf*cm
, 207 ft.*lbf
}
- HINT:
- Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).
- Using a chisel and hammer, stake the lock nut.
- CAUTION:
- Be sure that there are no cracks on the nut.