INSPECTION
Inspection · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Inspect the one-way clutch.
Set SST into the inner race of the one-way clutch.

- SST
- 09350-32014
(09351-32010)
Install SST so that it fits in the notch of the converter hub and outer race of the one-way clutch.
- SST
- 09350-32014
(09351-32010, 09351-32020)
Stand the torque converter up and turn the SST.

- Standard:
- If the one-way clutch is turned clockwise, it rotates freely and if turned counterclockwise, it locks.
Determine the condition of the torque converter clutch assembly.

If the inspection result of the torque converter clutch assembly satisfies the following conditions, replace the torque converter clutch assembly.
- Malfunction:
- A metallic sound is emitted from the torque converter clutch assembly during the stall test or when the shift lever is moved to N.
- The one-way clutch is free or locked in both directions.
- The amount of powder in the ATF is greater than the sample shown in the illustration (see the sample).
- HINT:
- The sample shows the ATF of approximately 0.025 liters (0.026 US qts, 0.022 Imp. qts) that is taken out from the removed torque converter clutch.
Replace the ATF in the torque converter clutch.
If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter clutch and drain it.
Clean and check the oil cooler and oil pipe line.

If the torque converter clutch is inspected or the ATF is exchanged, clean the oil cooler and oil pipe line.
- HINT:
- Spray compressed air of 196 kPa (2 kgf/cm2, 28 psi) into the inlet hose.
- If an excessive amount of powder is found in the ATF, add new ATF using a bucket pump and flush it again.
- Spray compressed air of 196 kPa (2 kgf/cm2, 28 psi) into the inlet hose.
If the ATF is cloudy, inspect the oil cooler (radiator).
Avoid damaging the torque converter and the oil pump gear.

When any marks due to interference are found on the end of the bolt for the torque converter or on the bottom of the bolt hole, replace the bolt and the torque converter clutch.
All of the bolts should be the same length.
Bolts with washers must be used.
| INSPECT DRIVE PLATE |
Check the drive plate for damage.
Set up a dial indicator and measure the runout of the 6 portions around the torque converter contact surface.

- Maximum runout:
- 0.30 mm (0.0118 in.)
