2006-2011 Camry Aurion · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL CLUTCH DISC ASSEMBLY

  1. C127508E01
    Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
    SST
    09301-00220  

    NOTICE:
    Take care not to insert the clutch disc assembly in the wrong direction.


2. INSTALL CLUTCH COVER ASSEMBLY

  1. C127509E02
    Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

  1. Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, evenly tighten the bolts one turn at a time.
    2. Lightly move SST up and down, and right and left after checking that the disc is in the center to tighten the bolts.

    SST
    09301-00210  


3. INSTALL RELEASE FORK SUPPORT

  1. C083809
    Install the release fork support to the manual transaxle assembly.

    Torque:
    47 N*m{ 480 kgf*cm , 35 ft.*lbf }


4. INSTALL RELEASE BEARING HUB CLIP
  1. Install the release bearing hub clip to the release bearing assembly.


5. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C128464E01
    Apply release hub grease to the contact surfaces between the release fork and release bearing, fork and push rod, and fork and fork support.

    Sealant:
    Part No. 08887-01806, RELEASE HUB GREASE or equivalent

  1. Install the release fork to the release bearing assembly.


6. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

  1. C133434
    Apply clutch spline grease to the input shaft spline as shown in the illustration.

    Sealant:
    Part No. 08887-01706, CLUTCH SPLINE GREASE or equivalent

  1. C069774
    Install the release fork with the release bearing assembly to the manual transaxle assembly.

    NOTICE:
    After installation, move the fork back and forth to check that the release bearing slides smoothly.


7. INSTALL CLUTCH RELEASE FORK BOOT

8. INSTALL MANUAL TRANSAXLE ASSEMBLY
Click here.
← REASSEMBLY (Oct 2006 – May 2009)PROBLEM SYMPTOMS TABLE (Jun 2006 – Sep 2006) →