B2791 Communication Condition Failure between ECM
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
DESCRIPTION
This DTC is output when the ID code box does not respond to a verification request signal from the ECM.- HINT:
- If the engine switch is turned off immediately after the engine starts, DTC B2791 will be detected. If DTC B2791 is cleared, this DTC will not recur because it does not indicate a malfunction.
- If this DTC B2791 is detected simultaneously with DTC B2799, troubleshoot B2799 first.
- If the engine switch is turned off immediately after the engine starts, DTC B2791 will be detected. If DTC B2791 is cleared, this DTC will not recur because it does not indicate a malfunction.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2791 |
ID code box does not respond to a verification request signal from ECM |
- |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the engine can be started even when DTC B2791 is output, the ID code box can be considered normal. Be sure to recheck for DTCs after clearing the DTCs (Click here).
| 1. CHECK ENGINE START |
Delete the DTCs (Click here).
Check that the engine starts.
- Result:
Result
Proceed to
Engine does not start
A
Engine starts
B
- HINT:
- Perform this step when the engine switch is turned off immediately after the engine starts.
|
|
||||
| A | |
| 2. CHECK DTC OUTPUT |
Recheck for DTCs (Click here).
- Result:
Result
Proceed to
B2791 and other DTC output
A
No DTC output
B
- HINT:
- If the engine does not start, DTC B2791 will not be detected separately from other DTCs because DTC B2791 will be output together with other DTCs. Troubleshoot DTCs other than DTC B2791.
|
|
||||
| A | ||
| ||
