2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL FRONT SHOCK ABSORBER
  1. Install the front spring bumper to the piston rod.

  1. Install the lower front coil spring insulator onto the front shock absorber.

  1. C104393E01
    Using SST, compress the front coil spring.
    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench.

    HINT:
    If the front coil spring is compressed at an angle, using 2 SST will make the work easier.

  1. C132419
    Install the front coil spring to the front shock absorber.

    NOTICE:
    The smaller diameter end of the front coil spring must face upward.

    HINT:
    Fit the lower end of the front coil spring into the gap of the insulator.

  1. C144432E01
    Install the upper front coil spring insulator as shown in the illustration.

    HINT:
    Any misalignment between the front shock absorber lower bracket and the matchmark must be +-5°.

  1. C132421E02
    Install the front coil spring upper seat with the mark facing to the outside of the vehicle.

    HINT:
    Any misalignment between the front shock absorber lower bracket and the matchmark must be +-5°.

  1. F040162
    Install a new front suspension support bearing as shown in the illustration.

    HINT:
    If there is foreign matter inside the front suspension support bearing, replace it with a new one.

  1. C144434E01
    Install the front suspension support sub-assembly as shown in the illustration.
    Temporarily tighten a new lock nut.

    NOTICE:
    Check that the flats on the piston rod and the flats on the front suspension support sub-assembly are aligned.

  1. C132423E01
    Remove the SST slowly in order to release the coil spring.

    NOTICE:
    Do not use an impact wrench.

    HINT:
    Any misalignment between the front shock absorber lower bracket and the arrows must be +-5°.

← INSPECTION (from Jun 2006)INSTALLATION (Jun 2006 – Sep 2006) →