INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT FRONT STABILIZER LINK ASSEMBLY |
Inspect the turning of the ball joint.

Secure the front stabilizer link assembly in a vise using aluminum plates.
Install the nut to the front stabilizer link assembly stud.
Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
- Turning torque:
- 0.05 to 2.0 N*m (0.5 to 20 kgf*cm, 0.4 to 18 in.*lbf)
- HINT:
- If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.
Inspect the dust cover.
Check that the dust cover is not cracked and that there is no grease on it.
- HINT:
- If there is any abnormality, replace the front stabilizer link assembly with a new one.
