Install the rear coil spring to the rear shock absorber.
NOTICE:
The smaller diameter end must face upward.
HINT:
Fit the lower end of the rear coil spring into the gap of the lower seat.
If the rear coil spring is compressed at an angle, using 2 SST will make the work easier.
Install the rear suspension support assembly.
NOTICE:
Align the notches of the piston rod and the rear suspension support assembly as shown in the illustration before installing the rear suspension support assembly.
Align the notches of the shock absorber with the notch of the rear suspension support assembly so that the notches face the outside of the vehicle.
Install the rear shock absorber collar.
Temporarily tighten a new lock nut to the rear shock absorber piston rod.
Release the spring while adjusting the rear suspension support assembly to the position shown in the illustration, and remove the SST from the rear coil spring.
NOTICE:
Do not use an impact wrench.
HINT:
When lining up the rear suspension support assembly's stud bolts at the middle point between the two sides of the bracket, the maximum permissible degree of error is +-5°.