2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver assembly.

WIRING DIAGRAM

E150784E08

INSPECTION PROCEDURE


1. CHECK BRAKE WARNING LIGHT
  1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning light operates as specified above.



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH - NAVIGATION RECEIVER)
  1. Disconnect the F13 navigation receiver assembly connector.

  1. Disconnect the E33*1 or A18*2 parking brake switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F13-1 (PKB) - E33-1*1
    Always
    Below 1 Ω
    F13-1 (PKB) - A18-1*2
    Always
    Below 1 Ω
    F13-1 (PKB) - Body ground
    Always
    10 kΩ or higher

    1. *1: for Lever Type
    2. *2: for Pedal Type



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. INSPECT PARKING BRAKE SWITCH

  1. E071372E01
    Disconnect the parking brake switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Switch connector - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector - Switch body
    OFF (When shaft is pressed)
    10 kΩ or higher

    Result:
    Result
    Proceed to
    OK
    A
    NG
    (for Lever Type)
    B
    NG
    (for Pedal Type)
    C



B
REPLACE PARKING BRAKE SWITCH (for Lever Type) (Click here)

C
REPLACE PARKING BRAKE SWITCH (for Pedal Type) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Illumination Circuit (from Jun 2009)Speaker Circuit (Jun 2006 – Sep 2006) →