2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Light Control Switch Circuit

Circuit diagnosis · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU receives the following switch information.
  1. Light control switch position is OFF, TAIL, HEAD, or AUTO
  2. Dimmer switch position is HIGH, LOW, or HIGH FLASH (PASS)
  3. Fog light switch position is OFF or ON

WIRING DIAGRAM

E121534E09

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Select the items below in the DATA LIST, and read the displays on the intelligent tester.

    Main Body (Main Body ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Dimmer Hi SW
    Dimmer switch HIGH signal / ON or OFF
    ON: Dimmer switch in HIGH
    OFF: Dimmer switch in LOW
    -
    Passing Light SW
    Dimmer switch FLASH signal / ON or OFF
    ON: Dimmer switch in HIGH FLASH (PASS)
    OFF: Dimmer switch not in HIGH FLASH (PASS)
    -
    Front Fog Light SW
    Front fog light switch signal / ON or OFF
    ON: Front fog light switch ON
    OFF: Front fog light switch OFF
    -
    Light Auto SW
    Light control switch AUTO signal / ON or OFF
    ON: Light control switch in AUTO
    OFF: Light control switch not in AUTO
    -
    Headlight SW
    Light control switch HEAD signal / ON or OFF
    ON: Light control switch in HEAD
    OFF: Light control switch not in HEAD
    -
    Taillight SW
    Light control switch TAIL signal / ON or OFF
    ON: Light control switch in TAIL or HEAD
    OFF: Light control switch in neither TAIL nor HEAD
    -

    OK:
    Normal conditions listed above are displayed.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
  1. Inspect the headlight dimmer switch assembly (Click here).



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY
OK


3. CHECK VEHICLE CONDITION

Result:
Vehicle Condition
Proceed to
LHD
A
RHD
B



B
Go to step 5
A


4. CHECK HARNESS AND CONNECTOR (SWITCH - INSTRUMENT PANEL J/B AND BODY GROUND)

  1. E121507E20
    Disconnect the E21 headlight dimmer switch assembly connector.

  1. Disconnect the E6 and E7 main body ECU connectors.

  1. Disconnect the IG instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-4 (BFG) - E6-28 (FFOG)
    Always
    Below 1 Ω
    E21-11 (HU) - IG-5 (HU)
    Always
    Below 1 Ω
    E21-17 (HF) - E7-13 (HF)
    Always
    Below 1 Ω
    E21-18 (T) - E7-23 (TAIL)
    Always
    Below 1 Ω
    E21-20 (H) - E6-17 (HEAD)
    Always
    Below 1 Ω
    E21-4 (BFG) - Body ground
    Always
    10 kΩ higher
    E21-11 (HU) - Body ground
    Always
    10 kΩ higher
    E21-17 (HF) - Body ground
    Always
    10 kΩ higher
    E21-18 (T) - Body ground
    Always
    10 kΩ higher
    E21-20 (H) - Body ground
    Always
    10 kΩ higher
    E21-12 (EL) - Body ground
    Always
    Below 1 Ω
    E21-3 (LFG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

5. CHECK HARNESS AND CONNECTOR (SWITCH - INSTRUMENT PANEL J/B AND BODY GROUND)

  1. E121507E21
    Disconnect the E21 headlight dimmer switch assembly connector.

  1. Disconnect the E6 and E7 main body ECU connectors.

  1. Disconnect the IG instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-7 (BFG) - E6-28 (FFOG)
    Always
    Below 1 Ω
    E21-11 (H) - E6-17 (HEAD)
    Always
    Below 1 Ω
    E21-12 (A) - E7-21 (A)
    Always
    Below 1 Ω
    E21-13 (T) - E7-23 (TAIL)
    Always
    Below 1 Ω
    E21-14 (HF) - E7-13 (HF)
    Always
    Below 1 Ω
    E21-20 (HU) - IG-5 (HU)
    Always
    Below 1 Ω
    E21-7 (BFG) - Body ground
    Always
    10 kΩ higher
    E21-11 (H) - Body ground
    Always
    10 kΩ higher
    E21-12 (A) - Body ground
    Always
    10 kΩ higher
    E21-13 (T) - Body ground
    Always
    10 kΩ higher
    E21-14 (HF) - Body ground
    Always
    10 kΩ higher
    E21-20 (HU) - Body ground
    Always
    10 kΩ higher
    E21-19 (EL) - Body ground
    Always
    Below 1 Ω
    E21-8 (LFG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


← Front Fog Light Circuit (from Jun 2009)Light Control Switch Circuit (from Jun 2009) →