2006-2011 Camry Aurion · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT SKID CONTROL SENSOR
  1. Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:

    1. The surface of the skid control sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The skid control sensor has been dropped.

  1. C113377E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH:
    Tester Connection
    Specified Condition
    2 (RL+) - 1 (RL-)
    Below 2.2 kΩ
    2 (RL+) - Body ground
    10 kΩ or higher
    1 (RL-) - Body ground
    10 kΩ or higher
    RH:
    Tester Connection
    Specified Condition
    2 (RR+) - 1 (RR-)
    Below 2.2 kΩ
    2 (RR+) - Body ground
    10 kΩ or higher
    1 (RR-) - Body ground
    10 kΩ or higher

    If the value is not as specified, replace the skid control sensor.

← REMOVAL (from Jun 2009)INSTALLATION (Jun 2006 – Sep 2006) →