REPLACEMENT
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 2.
SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the bolt and separate the flexible hose from the shock absorber.
- Remove the 2 bolts and separate the rear disc brake caliper assembly.
- NOTICE:
- Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
| 3.
REMOVE REAR DISC
|
 |
- Put matchmarks on the rear disc and the axle hub.
- Release the parking brake and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.
| 4.
REMOVE REAR AXLE HUB BOLT |
 |
- Temporarily install the 2 nuts and washers to the rear axle hub bolt as shown in the illustration.
Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
- SST
- 09628-10011
| 5.
INSTALL REAR AXLE HUB BOLT |
 |
- Install a washer and nut to a new bolt as shown in the illustration.
Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
| 6.
INSTALL REAR DISC
|
 |
- Aligning the matchmarks, install the rear disc.
- HINT:
- When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.
| 7.
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the rear disc brake caliper with the 2 bolts.
-
Torque:
- for LHD:
- 62 N*m{
632 kgf*cm
, 46 ft.*lbf
}
- for RHD:
- 47 N*m{
479 kgf*cm
, 35 ft.*lbf
}
- NOTICE:
- Do not twist the brake hose when installing the rear disc brake caliper assembly LH.
- Install the rear flexible hose with the bolt.
-
Torque:
- 19 N*m{
192 kgf*cm
, 14 ft.*lbf
}
| 8.
INSTALL REAR WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}