ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| INSPECT THROTTLE BODY ASSEMBLY |
Check for the throttle control motor operating sounds.
Turn the ignition switch on (IG).
When pressing the accelerator pedal position sensor lever, listen to the running motor. Make sure that no friction noise comes from the motor.
If friction noise exists, replace the throttle body assembly.
Inspect the throttle position sensor.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Check that the MIL turns off.
Under CURRENT DATA, the throttle valve opening percentage (Throttle Position) should be within the standard range below.
- Standard throttle valve opening percentage:
- 60% or more
- NOTICE:
- When checking the throttle valve opening percentage, the transmission should be in neutral.
